DMC:V2500-00-70-31-19-00A-623A-DIssue No:001.00Issue Date:2013-03-20
Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 70-31-19-100-501 Make-Up Of The Solution To Remove Flux After A Part Is Brazed
NOTE
To identify consumable materials refer to the PCI.
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| Stainless steel tank | LOCAL | Stainless steel tank | (with stainless steel heating coil) |
Consumables, Materials and Expendables
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| CoMat 01-022 SODIUM HYDROXIDE NaOH (SOLID) | LOCAL | CoMat 01-022 |
Spares
NONESafety Requirements
WARNING
IT IS THE RESPONSIBILITY OF THE OPERATOR TO OBTAIN AND OBSERVE THE MANUFACTURER'S MATERIAL SAFETY DATA SHEETS FOR CONSUMABLE MATERIALS. THESE CONTAIN INFORMATION SUCH AS, HAZARDOUS INGREDIENTS, PHYSICAL/CHEMICAL CHARACTERISTICS, FIRE, EXPLOSION, REACTIVITY, HEALTH HAZARD DATA, PRECAUTIONS FOR SAFE HANDLING, USE AND CONTROL MEASURES AND ALSO TO TAKE LOCAL REGULATIONS INTO CONSIDERATION.
WARNING
OPERATORS MUST ALWAYS WEAR THE PROTECTIVE CLOTHING SUPPLIED, WHICH INCLUDES EYE PROTECTION AND RUBBER GLOVES.
WARNING
IF SODIUM HYDROXIDE SOLUTION GETS INTO THE EYES, FULLY FLUSH THEM WITH CLEAN WATER AND THEN GET MEDICAL AID IMMEDIATELY.
WARNING
CAREFULLY ADD TO WATER THE COMPOUNDS WHICH CONTAIN SOLID SODIUM HYDROXIDE, BECAUSE HEAT IS RELEASED WHEN THE COMPOUND DISSOLVES. MAKE MUCH MOVEMENT OF THE SOLUTION, WITH AIR OR MECHANICAL METHODS, AS YOU ADD THE COMPOUND TO THE SURFACE OF THE SOLUTION. DO NOT ADD LARGE QUANTITIES OF THE COMPOUND TO ONE SMALL AREA OF THE TANK BECAUSE THE SOLUTION WILL BOIL.
WARNING
THE INSTRUCTIONS GIVEN BY THE SAFETY OFFICER MUST ALWAYS BE OBEYED.
Procedure
This aqueous solution consists of 13.5 oz/gal (100 g/l) of CoMat 01-022 SODIUM HYDROXIDE NaOH (SOLID) sodium hydroxide.
SUBTASK 70-31-19-100-001 Make-up and Set-up of Sodium Hydroxide