TASK 70-37-09-370-501 Stress-Relief Cycle 4A

DMC:V2500-00-70-37-09-00A-634A-D|Issue No:001.00|Issue Date:2013-03-20

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 70-37-09-370-501 Stress-Relief Cycle 4A

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

WARNING

IT IS THE RESPONSIBILITY OF THE OPERATOR TO OBTAIN AND OBSERVE THE MANUFACTURERS MATERIAL SAFETY DATA SHEETS FOR CONSUMABLE MATERIALS INFORMATION SUCH AS, HAZARDOUS INGREDIENTS, PHYSICAL/CHEMICAL CHARACTERISTICS, FIRE, EXPLOSION, REACTIVITY, HEALTH HAZARD DATA, PRECAUTIONS FOR SAFE HANDLING, USE AND CONTROL MEASURES AND ALSO TO TAKE LOCAL REGULATIONS INTO CONSIDERATION.

Procedure

    1. SUBTASK 70-37-09-370-001 Stress-Relief Cycle 4A

    1. Put the part in a cold oven. Air is a permitted atmosphere.

    2. Increase the temperature of the part to 600 deg F (316 deg C) and hold for 30 minutes.

    3. Increase the temperature of the part to 800 deg F (427 deg C) and hold for 30 minutes.

    4. Increase the temperature of the part to 1100 deg F (593 deg C) and hold for 30 minutes.

    5. Increase the temperature of the part to 1275 to 1325 deg F (691 to 718 deg C) and hold for two hours.

    6. Decrease the temperature of the part to 500 deg F (260 deg C) not faster than 100 deg F (56 deg C) every 15 minutes. Subsequent temperature decrease rate is optional.

Requirements After Job Completion

Follow-On Conditions

NONE