TASK 70-39-00-390-501 Machine Riveting - General Information

DMC:V2500-00-70-39-00-00A-624A-D|Issue No:001.00|Issue Date:2013-03-20

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Description

  1. TASK 70-39-00-390-501 Machine Riveting - General Information

    WARNING

    IT IS THE RESPONSIBILITY OF THE OPERATOR TO OBTAIN AND OBSERVE THE MANUFACTURERS MATERIAL SAFETY DATA SHEETS FOR CONSUMABLE MATERIALS INFORMATION SUCH AS, HAZARDOUS INGREDIENTS, PHYSICAL/CHEMICAL CHARACTERISTICS, FIRE, EXPLOSION, REACTIVITY, HEALTH HAZARD DATA, PRECAUTIONS FOR SAFE HANDLING, USE AND CONTROL MEASURES AND ALSO TO TAKE LOCAL REGULATIONS INTO CONSIDERATION.

    1. Safety Precautions

    2. General

      1. Machine Riveting refers to the connection of parts by a rivet put through aligned holes, and peen the end that causes the parts to be locked together.

      2. The general conditions apply to riveting repairs follow.

        1. The rivet hole must be deburred before the rivet is put into it.

        2. All aluminium rivets, or steel rivets in aluminium material, must have a layer of the applicable corrosion resistant paint put on it before rivets are installed.

        3. Rivets must be installed with the machined head tightly against the material surface, and adjacent surfaces of materials that are riveted must be in strong touch with each other before the head is shaped.