TASK 70-51-00-510-501 Shipping - General Information

DMC:V2500-00-70-51-00-00A-800A-D|Issue No:001.00|Issue Date:2013-03-20

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Description

  1. TASK 70-51-00-510-501 Shipping - General Information

    WARNING

    IT IS THE RESPONSIBILITY OF THE OPERATOR TO OBTAIN AND OBSERVE THE MANUFACTURERS MATERIAL SAFETY DATA SHEETS FOR CONSUMABLE MATERIALS INFORMATION SUCH AS, HAZARDOUS INGREDIENTS, PHYSICAL/CHEMICAL CHARACTERISTICS, FIRE, EXPLOSION, REACTIVITY, HEALTH HAZARD DATA, PRECAUTIONS FOR SAFE HANDLING, USE AND CONTROL MEASURES AND ALSO TO TAKE LOCAL REGULATIONS INTO CONSIDERATION.

    WARNING

    MAKE SURE THAT MODULES OR COMPONENT PARTS ARE CORRECTLY LABELLED AND THAT FUEL SYSTEM COMPONENTS SHOW APPROVED FUEL SYSTEM WARNINGS.

    1. Safety Precautions

    2. General

      The data contained in this section gives help to make sure safe shipping of engines and modules.

      Special instructions applicable for when you move engines and modules are contained in the Engine Manual.

    3. Preparation and Handling

      Preparation and handling of module and component parts for shipping.

      1. Preparation

        1. Prepare and store modules and component parts as given in the Engine Manual.

      2. Container Handling

        1. Installation and removal of containers must be done with an applicable fork lift truck or lifting sling.

      3. Container/Secure

        1. Movement of containers during shipping must be prevented by the approved procedure applicable to the equipment used.

          1. Correctly held with rope and attached rings

          2. Correctly held with adjustable chains.

          3. Attach containers to a rigid pallet type of equipment.

          4. Apply applicable chock methods.

      4. Weather Protection

        1. Make sure that correct protection covers, such as tarpaulins are attached over containers to guard against bad weather conditions.

    4. Documentation

      1. Documentation/Inspect

        1. Before you send the container make sure that documentation (ie Advice and Release notes, IAE forms, module and container log cards and module identification labels) applicable to the container being moved, are attached in, or attached satisfactorily to, the container.

    5. Container Markings

      1. Container/Label

        1. Make sure that container markings are clearly specified and address labels correctly attached to the container.

      2. Toggle fasteners/Inspect

        1. Make sure that all toggle fasteners are correctly attached and are locked with wire in the safety position.