TASK 71-52-43-300-001 EEC Core Harness And Voltage Divider Harness Assembly - Wind Up The Tape To The EEC Core Harness, Repair-001 (VRS1071)

DMC:V2500-A0-71-52-4300-00A-611A-C|Issue No:001.00|Issue Date:2014-05-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 71-52-43-300-001 EEC Core Harness And Voltage Divider Harness Assembly - Wind Up The Tape To The EEC Core Harness, Repair-001 (VRS1071)

Effectivity

FIG/ITEM

PART NO.

01-005

2A1497

01-005

6A5554

General

The practices and processes referred to in the procedure by the TASK number are in the SPM.

For the method to clean the parts, refer to TASK 71-52-43-100-301.

Repair parts

FIG/ITEM

PART NO.

PART IDENT

QTY

03-960

AIR-TEX 360

Tape, lacing

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NameManufacturerPart Number / IdentificationQuantityRemark
CoMat 02-195 TEFLON TAPELOCALCoMat 02-195

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 71-52-43-350-051 Remove the Spot Tie

    1. CAUTION

      DO NOT CUT THE CABLE.

      Cut off and remove the spot ties from damaged area.

    2. SUBTASK 71-52-43-350-052 Wind up the Teflon Tape

    1. Refer to Figure.

    2. If necessary neatly restrand exposed screen braid.

      3. Wind up the teflon tape

      1. NOTE

        Extend approximately 1 in. longer, either side of the damaged area.

    3. SUBTASK 71-52-43-350-053 Attach Spot Tie

    1. Refer to Figure.

      2. Attach spot tie

      1. Use lacing tape.

    4. Figure: Wind Up The Tape The Cable

    Wind Up The Tape The Cable

    Figure: Fitting Of Spot Tie

    Fitting Of Spot Tie

Requirements After Job Completion

Follow-On Conditions

NONE
Manufacturer Code:LOCAL
Enterprise Name:LOCALLY SUPPLIED
Manufacturer Code:LOCAL
Supply Number:CoMat 02-195
Type:sp01
Supply Short Name:CoMat 02-195 TEFLON TAPE
Supply Name:CoMat 02-195 TEFLON TAPE
Specification Groups:
Doc NumberType
3M No.62 MIL-I-23594 JCR-263
Suppliers:
ManufacturerRemarks
LOCAL
76381
81349