DMC:V2500-A0-72-32-3800-01A-649A-CIssue No:002.00Issue Date:2016-08-01
Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 72-32-38-300-002 No. 1 Bearing Compartment Rear Seal Drain Tube - Repair Surface Damage, Repair-002 (VRS1738)
General
Price and availability - none
The practices and processes referred to in the procedure by the TASK number are in the SPM.
NOTE
To identify the consumable materials refer to the PCI.
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| Fluorescent Penetrant Inspection Equipment | LOCAL | Fluorescent Penetrant Inspection Equipment |
Consumables, Materials and Expendables
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| CoMat 05-020 WATERPROOF SILICON CARBIDE | LOCAL | CoMat 05-020 | ||
| CoMat 05-021 WATERPROOF SILICON CARBIDE | 44197 | CoMat 05-021 |
Spares
NONESafety Requirements
NONEProcedure
Refer to Figure.
Refer to the SPM TASK TASK 70-35-03-300-501.
The surface finish of the repair must be the same as the adjacent area.
Use abrasive stones or papers and/or fine file.
Remove the nicks, galls and/or burrs
SUBTASK 72-32-38-350-052 Remove the Nicks, Galls and/or Burrs from the Tube Surface, Flange and Sealing Groove Lands
Visually examine the repaired area for nicks, galls and/or burrs.
Use a 10X magnifying glass.
Visually examine the tube surface and tube end fitting
SUBTASK 72-32-38-220-059 Examine the Seal Drain Tube Assembly
Refer to the SPM TASK 70-23-05-230-501.
Make sure there are no cracks in repaired area.
Do a crack test on the parts
SUBTASK 72-32-38-230-056 Examine the Seal Drain Tube Assembly for Cracks
Figure: Repair Details And Dimensions
Repair Details And Dimensions
