TASK 72-41-33-300-016 HPC Stage 3 Variable Stator Vane Shroud Half Seal - Repair The Surface Protection, Repair-016 (VRS 6347)

DMC:V2500-A0-72-41-3323-00A-609A-C|Issue No:001.00|Issue Date:2013-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 72-41-33-300-016 HPC Stage 3 Variable Stator Vane Shroud Half Seal - Repair The Surface Protection, Repair-016 (VRS 6347)

Effectivity

FIG/ITEM

PART NO.

02-150

6A1093

Material of component

PART IDENT

SYMBOL

MATERIAL

Seal, half ring - Stage 3

LJH

Aluminum Copper Magnesium Iron Alloy

General

This Repair must only be done when the instruction to so is given in TASK 72-41-33 INSPECTION/CHECK.

This repair replaces the surface protection on the HP Compressor, Stage 3, inner seal ring.

The practices and processes referred to in the procedure by the TASK/SUBTASK numbers are the SPM.

Price and availability

Refer to International Areo Engines

Related repairs - none

NOTE

  1. Equivalent materials or equipment can be used.

  2. More equipment and materials necessary to do this Repair are in TASK given below:

    TASK 70-38-02-300-503

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 72-41-33-380-058 Replace the Surface Protection

    1. Refer to Fig. 72-41-33-990-024.

      2. Apply the surface protection as necessary.

      1. Refer to the SPM TASK 70-38-02-300-503.

    2. Figure: Repair details and dimensions

    Repair details and dimensions

Requirements After Job Completion

Follow-On Conditions

NONE