TASK 72-60-23-300-020 Hydraulic Pump Drive Gear Housing - Replace The Damaged Sleeve, Repair-020 (VRS5417)

DMC:V2500-A0-72-60-2304-03A-920A-C|Issue No:001.00|Issue Date:2013-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 72-60-23-300-020 Hydraulic Pump Drive Gear Housing - Replace The Damaged Sleeve, Repair-020 (VRS5417)

Effectivity

FIG/ITEM

PART NO.

01-460

4B0192

01-460

4B0313

01-460

4B0350

01-460

4B0372

Material of component

PART IDENT

SYMBOL

MATERIAL

Housing

Aluminum alloy

General

Price and availability - none

The practices and processes referred to in the procedure by the TASK number are in the SPM.

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NameManufacturerPart Number / IdentificationQuantityRemark
Workshop inspection equipmentLOCALWorkshop inspection equipment
Hot air gunLOCALHot air gun

Consumables, Materials and Expendables

NONE

Spares

NameManufacturerPart Number / IdentificationQuantityRemark
Sleeve4P01141

Safety Requirements

NONE

Procedure

    1. SUBTASK 72-60-23-350-087 Remove the Sleeve

      1. Heat the housing adjacent to the sleeve.

      1. Use the hot air gun.

      2. Drift out the sleeve from the housing.

      1. Use a standard drift.

    2. SUBTASK 72-60-23-350-088 Install the New Sleeve

      1. Examine the fit.

      1. Be sure there is a tight fit between the outer diameter of the new sleeve and the corresponding hole in the housing.

      2. Heat the housing adjacent to the hole.

      1. Use the hot air gun.

    3. Install the new sleeve.

Requirements After Job Completion

Follow-On Conditions

NONE
Link not Found
Manufacturer Code:LOCAL
Enterprise Name:LOCALLY SUPPLIED
Link not Found
Link not Found
Manufacturer Code:LOCAL
Tool Number:Workshop inspection equipment
Tool Name:Workshop inspection equipment