Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 73-22-15-100-401 P3/T3 Sensor - Related Parts - Clean The P3/T3 Sensor, Cleaning-001
General
This TASK gives the procedure to clean the P3/T3 sensor. For the other parts of the P3/T3 sensor, refer to Cleaning-000 TASK 73-22-15-100-400.
The practices and processes referred to in the procedure by the TASK numbers are in the SPM.
Fig/item numbers in parentheses in the procedure agree with those used in the IPC. Only the primary Fig/item numbers are used. For the service bulletin alpha variants refer to the IPC.
NOTE
Reference
Refer to SPM TASK 70-10-00-100-501 Cleaning - General Information.
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
NONEConsumables, Materials and Expendables
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| CoMat 02-054 BRUSH, TAMPICO | 045J7 | CoMat 02-054 |
Spares
NONESafety Requirements
NONEProcedure
Moderate cleaning.
Remove the grease and unwanted particles. Refer to SPM TASK 70-11-03-300-503.
SUBTASK 73-22-15-110-051-001 Remove the Grease and Unwanted Particles
Vapor degreasing.
Clean the surface and the threaded area of the protective housing. Use CoMat 02-054 BRUSH, TAMPICO to remove unwanted material from between the studs and the stud box.
Remove the grease and unwanted particles. Refer to SPM TASK 70-11-01-300-503.
SUBTASK 73-22-15-110-051-002 Remove the Grease and Unwanted Particles