Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
V2500-A5
Common Information
TASK 71-00-00-700-057-B00 Procedure After Engine Overtemperature (With Surge Or Stall), Testing-000
Procedure After Engine Overtemperature (With Surge or Stall)
Procedure
Quickly and immediately move the thrust lever to IDLE.
Select the FUEL OFF mode.
When the N2 RPM decreases below 1495 RPM (10%), engage the starter and motor the engine. Continue to motor the engine at more than 2500 N2 RPM until the EGT has decreased below 482 deg F (250 deg C), or for two minutes, whichever is reached first.
Write how much time the temperature was more than the limit and the highest temperature for subsequent analysis. This is a very important step if IAE representative assistance is requested.
Correct the cause of overtemperature. Refer to the fault isolation TASK 71-00-00-810-017 (FAULT ISOLATION-017).
If the overtemperature was mild and the engine can be started again, refer to procedure for a Bowed Rotor Start Prevention after an Emergency Shutdown. Refer to TASK 71-00-00-700-065-B00 (TESTING-000, CONFIG-002).