Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 72-00-00-300-014No. 3 Bearing Replacement - Project Visit Maintenance, Repair-014 (VRS3831)
General
This procedure outlines the requirements to remove a suspect No. 3 Bearing Assembly, inspect all engine hardware to extent exposed and re-assemble a new No. 3 Bearing Assembly.
It is not intended to be utilized for normal shop visits for the purpose of scheduled engine/module overhaul or refurbishment where a full on-wing interval is expected. This procedure alone does not permit any engine to be zero-timed (time since LEVEL 3 maintenance).
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
NONEConsumables, Materials and Expendables
NONESpares
NONESafety Requirements
NONEProcedure
The designation by IAE of an authorized vendor indicates that the repair vendor has demonstrated the necessary capability to enable it to carry out the listed repair work. However, IAE makes no warranties or representations concerning the qualifications or quality standards of the repair vendors to carry out the repair work and accepts no responsibility whatsoever for any work that may be carried out by a repair vendor, other than when IAE Is listed as the repair vendor. Authorized repair vendors do not act as agents or representatives of IAE.
The proprietary nature of this repair requires that any facility not authorized to accomplish this repair contact the IAE Repair Development Group to determine if a qualification program can be initiated at their facility.
IAE International Aero Engines AG
400 Main Street
M/S 121-10
East Hartford CT 06118
U.S.A.
Attn: Manager Technical Services