DMC:V2500-A0-72-32-1601-00A-920A-CIssue No:002.00Issue Date:2021-05-01
Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 72-32-16-300-011 Gearshaft Bearing Housing - Replace The Thread Insert, Repair-011 (VRS1195)
General
The practices and processes referred to in the procedure by the TASK number are in the SPM.
Price and availability - not applicable
NOTE
To identify the consumable materials refer to the PCI.
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| Fluorescent Penetrant Inspection Equipment | LOCAL | Fluorescent penetrant inspection equipment |
Consumables, Materials and Expendables
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| CoMat 04-004 JOINTING COMPOUND, LIGHT GRADE | LOCAL | CoMat 04-004 | ||
| CoMat 10-077 APPROVED ENGINE OILS | X333X | CoMat 10-077 |
Spares
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| INSERT - SCREW THREAD,(VRS6514), .250 DIA X 1.5D | 4 |
Safety Requirements
NONEProcedure
Refer to Figure.
Refer to the SPM TASK 70-35-08-300-501.
Remove the damaged insert.
SUBTASK 72-32-16-350-053 Remove the Damaged Insert
Refer to Figure.
Refer to the SPM TASK 70-35-08-300-501.
Apply compound to the thread of the new helical insert.
Refer to the SPM TASK 70-35-08-300-501.
Refer to Figure.
Install the new helical insert.
Refer to the SPM TASK 70-35-08-300-501.
Remove the tang.
SUBTASK 72-32-16-220-082 Install the New Insert
Refer to Figure.
Refer to the SPM TASK 70-35-08-300-501.
Deleted
Visually examine the installed insert.
Refer to the SPM TASK 70-35-08-300-501.
Torque check the installed insert.
SUBTASK 72-32-16-230-056 Examine the Installed Insert
Figure: Gearshaft bearing housing assembly - replace the thread insert
Gearshaft bearing housing assembly - replace the thread insert
