DMC:V2500-A0-72-32-2200-00A-920A-CIssue No:001.00Issue Date:2013-11-01
Export Control
EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.Copyright
© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).Applicability
All
Common Information
TASK 72-32-22-300-003 No. 3 Bearing Seal Support - Replace The Inserts, Repair-003 (VRS3003)
General
This Repair must only be done when the instruction to do so is given in TASK 72-32-22-200-000 Inspection.
Price and availability - refer to IAE
The practices and processes referred to in the procedure by the TASK number are in the SPP.
NOTE
The tools for the removal and the installation of the inserts can be purchased from Heli-Coil Products Division/Mite Corporation Supplier Code 01556, Danbury, CT. 06810, USA.
Preliminary Requirements
Pre-Conditions
NONESupport Equipment
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| Removal tool | LOCAL | 1227-6 | (Heli-Coil Products) | |
| Tang removal tool | LOCAL | 3695-4 | (Heli-Coil Products) | |
| Installation tool | LOCAL | 7552-4 | (Heli-Coil Products) |
Consumables, Materials and Expendables
NONESpares
| Name | Manufacturer | Part Number / Identification | Quantity | Remark |
|---|---|---|---|---|
| Screw thread insert | MS21209F4-10 | 9 |
Safety Requirements
NONEProcedure
Refer to Figure.
Refer to the SPM TASK 70-35-08-300-501.
Use Removal tool.
Remove the damaged or loose inserts.
SUBTASK 72-32-22-350-052 Remove the Damaged or Loose Inserts
Refer to Figure.
Refer to the SPM TASK 70-35-08-300-501.
Use the Installation tool and the Tang removal tool.
Install the new inserts and break off the tangs.
SUBTASK 72-32-22-350-053 Install the New Inserts
Refer to Figure.
SUBTASK 72-32-22-220-061 Examine the Inserts
Figure: No. 3 bearing seal support assembly insert repair
No. 3 bearing seal support assembly insert repair
