TASK 72-40-00-100-012 Loop Clamp Brackets - Clean, Cleaning-012

DMC:V2500-A0-72-40-0036-00A-251A-C|Issue No:001.00|Issue Date:2013-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 72-40-00-100-012 Loop Clamp Brackets - Clean, Cleaning-012

Effectivity

FIG/ITEM

PART NO.

01-060

2A0406

01-070

2A1225

01-070

2A3281

01-080

2A0876

01-080

2A1939

01-080

2A3373

01-100

2A1196

01-140

2A0878

01-140

2A1938-01

01-160

2A0929

01-160

2A1963

01-161

2A1964

01-170

2A0897

01-170

2A1952-01

01-194

2A2529-01

01-194

2A3275

01-197

2A2537

01-250

2A2546

01-310

2A3279

01-435

2A2542-01

General

This TASK gives the procedure to clean the loop clamp brackets. For the other parts of the HP system module, refer to TASK 72-40-00-100-000 (CLEANING-000)

The practices and processes referred to in the procedure by the TASK numbers are in the SPM.

Fig/item numbers in parentheses in the procedure agree with those used in the IPC. Only the primary Fig/item numbers are used. For the service bulletin alpha variants, refer to the IPC.

Reference

Refer to General Cleaning, Section 70-10-00, in the Standard Practices Manual (SPM) for important cleaning information that supplements the TASKs

When more than one TASK or SUBTASK is specified for a part, refer to Section 70-10-00 in the SPM for selection of the applicable cleaning TASK or SUBTASK.

Refer to Section 70-11-00 in the SPM for the TASK numbers given below.

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 72-40-00-110-066 Remove the Grease and Oil

      1. Remove the grease and oil. Refer to the SPM TASK 70-11-03-300-503.

      1. Degrease parts by aqueous cleaning.

    2. SUBTASK 72-40-00-110-087 Remove the Rust and Carbon

      1. Remove the rust and carbon. Refer to the SPM TASK 70-11-13-300-503.

      1. Cleaning of components (long soak, for cobalt and nickel base alloys and heat and non-corrosion resistant steels).

Requirements After Job Completion

Follow-On Conditions

NONE