TASK 72-32-91-040-001 LPC Inlet Guide Vane (Stator) Assembly - Disassemble The Vane Assembly From The Splitter, Disassembly-001

DMC:V2500-A1-72-32-9100-00A-530A-B|Issue No:001.00|Issue Date:2013-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

V2500-A1 AND Post SBE 72-0103

Common Information

TASK 72-32-91-040-001 LPC Inlet Guide Vane (Stator) Assembly - Disassemble The Vane Assembly From The Splitter, Disassembly-001

General

Fig/item numbers in parentheses in the procedure agree with those used in the IPC. Only the primary Fig/item numbers are used. For the service bulletin alpha variants refer to the IPC.

Apply the approved penetrating oil before the removal of threaded parts. Let the parts soak before removal. For the approved oils and procedures, refer to the SPM TASK 70-64-00-640-501.

Refer to TASK 72-32-91-440-001 for a sectional view of the fan outlet inner vane assembly.

NOTE

Special tools are identified in the procedure by the tool primary number.

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NameManufacturerPart Number / IdentificationQuantityRemark
IAE 1J12414 Holding block set0AM53IAE 1J124141

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 72-32-91-040-051 Disassemble the Fan Outlet Inner Vane Assembly

    1. Refer to Figure.

    2. Put the four holders (part of IAE 1J12414 Holding block set 1 off) in a circular position. The four holders must be equally put apart. The diameter of the circle must be equal to the diameter of the splitter fairing.

    3. Install the fan outlet inner vane assembly on to the holders with front end down.

    4. Remove the 46 screws which attach the LPC inlet guide vane to the splitter fairing with a torque set screwdriver.

    5. Move the fan outlet inner vane assembly on to the work bench.

    6. Hit the splitter fairing lightly at the rear edge with a soft headed mallet to release it from the LPC inlet guide vane.

    2. Figure: Disassemble the fan outlet inner vane assembly

    Disassemble the fan outlet inner vane assembly

Requirements After Job Completion

Follow-On Conditions

NONE
Manufacturer Code:0AM53
Enterprise Name:IAE INTERNATIONAL AERO ENGINES AG
BU Name:NULL
Building:SUITE 400
Street:628 HEBRON AVENUE
City:GLASTONBURY
State:CT
Zip Code:06033
Country:USA
Manufacturer Code:0AM53
Tool Number:IAE 1J12414
Tool Name:IAE 1J12414 Holding block set