TASK 73-13-41-100-201 Fuel Nozzle And Support Assembly - Clean The Fuel Nozzle With Heat (Pyrolytic Cleaning)

DMC:V2500-A0-73-13-4100-00A-258A-C|Issue No:001.00|Issue Date:2013-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 73-13-41-100-201 Fuel Nozzle And Support Assembly - Clean The Fuel Nozzle With Heat (Pyrolytic Cleaning)

Effectivity

FIG/ITEM

PART NO.

01-020

2A0994

01-020

2A1637

01-020

2A2250

01-020

2A3448

01-020

2A3453

General

This TASK gives the procedure to clean the fuel nozzle and support assembly with heat (pyrolytic cleaning). An alternative to this procedure is given in Cleaning-003 TASK 73-13-41-100-203.

The practices and processes referred to in this procedure by the TASK numbers are in the SPM.

Fig/item numbers in parentheses in the procedure agree with those used in the IPC. Only the primary Fig/item numbers are used. For the service bulletin alpha variants refer to the IPC.

Reference

Refer to SPM TASK 70-10-00-100-501, Cleaning - General Information.

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NameManufacturerPart Number / IdentificationQuantityRemark
OvenLOCALOven

Variable to 1100 deg F (593 deg C) - local purchase

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 73-13-41-160-051 Clean the Fuel Nozzle and Support Assembly with Heat

    1. CAUTION

      MAKE SURE THE FUEL IS COMPLETELY REMOVED AND THE ASSEMBLY IS BACKFLUSHED AND AIR-DRIED BEFORE YOU CLEAN THE ASSEMBLY. THIS WILL REMOVE LOOSE CONTAMINATION AND PREVENT POSSIBLE DAMAGE CAUSED BY REMAINING FUEL COMBUSTION.

      Flush the assembly. Refer to Cleaning-004 TASK 73-13-41-100-204.

      2. CAUTION

        DO NOT EXCEED 1100 DEG F (593 DEG C) MAXIMUM.

        Turn the oven on. Set the temperature to 1000 deg F (538 deg C).

      1. Bake in air for up to eight hours.

    3. Remove the assembly from the oven.

    4. Flush the assembly. Refer to Cleaning-004 TASK 73-13-41-100-204.

Requirements After Job Completion

Follow-On Conditions

NONE
Manufacturer Code:LOCAL
Enterprise Name:LOCALLY SUPPLIED
Manufacturer Code:LOCAL
Tool Number:Oven
Tool Name:Oven