TASK 70-35-25-300-001-D01 Replace The Terminals Of The Electrical Harness, Repair-001 (VRS7002)

DMC:V2500-00-70-35-25-03A-920A-D|Issue No:002.00|Issue Date:2018-11-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 70-35-25-300-001-D01 Replace The Terminals Of The Electrical Harness, Repair-001 (VRS7002)

General

This TASK details the procedure for the replacement of the terminals of the electrical harness.

Refer to repair, VRS7002 SPM TASK 70-35-25-300-001 (REPAIR-001) for the following:

Effectivity

Equipment and materials

General

All illustrations/Figs

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 70-35-25-350-027 Remove Damaged Terminals

    1. CAUTION

      DO NOT CUT THE CONDUCTOR.

      Refer to Figure.

    2. Remove the terminal.

      3. Remove the insulation from the cable.

      1. Use a cable stripper.

    2. SUBTASK 70-35-25-350-028 Install the Terminal

    1. Refer to Figure

      2. Install the terminal.

      1. Put the conductor into the terminal barrel. Use a crimping tool.

      3. Install the cable identification sleeve.

    3. SUBTASK 70-35-25-350-029 Install the Alumel and Chromel Terminals

    1. Refer to Figure.

    2. Install the glass fabric tube.

      3. Install the terminal.

      1. Put the conductor into the terminal barrel. Use a crimping tool.

      4. Fusion weld the terminal barrel.

      1. Refer to SPM TASK 70-31-13-310-501.

      5. Install the cable identification sleeve.

    4. SUBTASK 70-35-25-350-054 Identify the Repair

      1. Make a mark VRS7002/D on the identification sleeve of the harness adjacent to the part number.

      1. Use permanent marker.

    5. Figure: Repair details and dimensions

    Repair details and dimensions

Requirements After Job Completion

Follow-On Conditions

NONE
Change Type:

Added identification procedure. (18VC225)

Change Type:

Revised the title. (Editorial)