TASK 72-00-00-500-006 Engine General - Remove The Engine From a VMI Bag, Storage-006

DMC:V2500-A0-72-00-0000-00A-840A-B|Issue No:001.00|Issue Date:2014-05-01

Export Control

EAR Export Classification: Not subject to the EAR per 15 C.F.R. Chapter 1, Part 734.3(b)(3), except for the following Service Bulletins which are currently published as EAR Export Classification 9E991: SBE70-0992, SBE72-0483, SBE72-0580, SBE72-0588, SBE72-0640, SBE73-0209, SBE80-0024 and SBE80-0025.

Copyright

© IAE International Aero Engines AG (2001, 2014 - 2021) The information contained in this document is the property of © IAE International Aero Engines AG and may not be copied or used for any purpose other than that for which it is supplied without the express written authority of © IAE International Aero Engines AG. (This does not preclude use by engine and aircraft operators for normal instructional, maintenance or overhaul purposes.).

Applicability

All

Common Information

TASK 72-00-00-500-006 Engine General - Remove The Engine From a VMI Bag, Storage-006

General

Refer to TASK 72-00-00-500-001 (STORAGE-001, CONFIG-001) General Data for Engine Storage.

Preliminary Requirements

Pre-Conditions

NONE

Support Equipment

NONE

Consumables, Materials and Expendables

NONE

Spares

NONE

Safety Requirements

NONE

Procedure

    1. SUBTASK 72-00-00-550-054 Remove the VMI Bag or Storage Cover from the Transportation Stand and Remove the Desiccant from the Bag/Cover

    1. CAUTION

      MAKE SURE THAT YOU DO NOT DAMAGE THE BAG/COVER DURING REMOVAL.

      Remove the front and rear freight guards from the transportation stand.

    2. Release the lock slider, then remove the top half of the bag/cover.

    3. Move the engine from the transportation stand to the support pedestals. Refer to TASK 71-00-00-560-001 (REMOVAL-001).

      4. Remove the front and rear support brackets.

      1. Remove the eight bolts and the eight washers that attach the front support brackets to the transportation stand.

      2. Remove the front support brackets and put them on a suitable surface.

      3. Remove the eight nuts and the eight bolts that attach the rear support brackets to the transportation stand.

      4. Remove the rear support brackets and put them on a suitable surface.

    5. Remove the bag/cover from the transportation stand. Remove the indicator and desiccant from the bag/cover.

      6. Install the front and rear support brackets.

      1. Attach the front support brackets to the front support struts on the transportation stand with the eight bolts and the eight washers.

      2. Tighten the bolts to safety.

      3. Attach the rear support brackets to the rear support struts on the transportation stand with the eight nuts and the eight bolts.

      4. Tighten the nuts and the bolts to safety.

    7. Move the engine from the support pedestals to the transportation stand. Refer to TASK 71-00-00-560-002 (INSTALLATION-001).

Requirements After Job Completion

Follow-On Conditions

NONE